Operation Manual

93
IRC REPORTS
(Collecting Transaction Data from Slaves)
There are two kinds of IRC reports issued by the master ECR;
One is a consolidated report for all ECR's sales data and
the other is an individual report, by designating the slave ECR by using the sequence below;
Set the control key to X, Z1 or Z2 position.
- 1st level for daily report : X (read only) position or Z1 (reset) position
- 2nd level for periodic report : X (read only) position or Z2 (reset) position
CONSOLIDATED (ALL ECRs) REPORT
INDIVIDUAL (PER ECR) REPORT
The master ECR can collect the slave ECR's sales data only when the slave ECR is in an idle condition
(no other communication, no transaction). When the slave ECR is transmitting sales data to the
master, the display shows "-> IRC COMM --" and ECR locks until IRC communication stops.
The following IRC reports are printed on the master and slave ECRs respectively.
'IRC Z report printed or not printed' can be programmed also.
Master prints Slave prints
Consolidated X-report
a consolidated report a confirmation report on journal only
Individual X-report
a designated slave's report a confirmation report on journal only
printed
own report and a consolidated report with
IRC status
own report
Consolidated
Z-report
not printed
own confirmation report and a consolidated
report with IRC status
a confirmation report on journal only
printed a designated slave's report with IRC status own report
Individual
Z-report
not printed a designated slave's report with IRC status a confirmation report on journal only
X/Z
Report #
X2
TTL
25
X/Z
Report #
X2
TTL
25
Slave ECR machine #