Operation Manual

23
MONTAGE
Parts list
No. 1 Screws M 6 x 20
No. 2 Washers (2 pcs)
No. 3 Base (1 pc.)
No. 4 Base cover (1 pc.)
No. 5 Holders
No. 6 Panels (2 pcs, mirrored
side facing downward)
No. 7 Hinged holder
No. 8 Hinges
1. Remove all packaging materials
and any transport safeguards.
Keep packaging materials away
from children.
2. Check whether all listed acces-
sory parts are present and intact.
3. First turn the housing over so that
the lower end is up.
4. Insert the two panels (6) on the
holders. Ensure that the side that
is slightly reflective points down-
ward for optical reasons.
5. Route the power cord through the
base. Note that the plug for the
electrical outlet must poke out on
the underside of the base. The
end of the power cord, on which
the connection socket is moun-
ted, must be threaded through
the housing. Fastening the power
cord with the cable clip.
6. Carefully place the base (3) in the
base cover (4) and place both the
base and base cover onto the hol-
ders (5) together.
7. Now place the washers (2) and
firmly screw all parts onto the
housing with screws M 6 x 20.
8. Turn the housing over again so
that it is now right side up.
9. Now attach the three hinges (8)
on the glass plate: Screw the hin-
ges onto the aluminium-coloured
holders of the glass plate with the
M 8 x 6 and M 4 x 6 screws.
10. No you can carefully insert the
glass plate into the three glass
plate holders (11).
11. Firmly screw the glass plate onto
the glass plate holders with the M
6 x 16 screws.
For set-up you require a Phillips head screwdriver and the hex socket srewdriver.
No. 9 Screws M 8 x 6
No. 10 Screws M 4 x 6
No. 11 Glass plate holders
No. 12 Screws M 6 x 16
No. 13 Cable-Clip (incl. Screws
M 4 x 35)