Instructions / Assembly

[e-mail]. Page: - 3 - / 3
Twist plastic wire connector until wires are tightly joined together, and wrap each connector with approved
electrical tape. Be sure that no wire strands are exposed and then carefully tuck all wires into the outlet box .
Step A4: Align the holes in the back plate (E) and the mounting plate (C), then secure the back plate (E)
with the previously removed screws (F) till snug.
Step A5: Fix the glass shade (I) to the socket (H) with the socket ring (J).
Install bulbs (Not included. Please do not exceed the maximum wattage recommended on the
socket.)
[e-mail].
Step A1: Unscrew the grub screw (F) from the back plate (E) then gently remove the mounting plate (
C).
Step A2: Secure mounting plate (C) to outlet box with mounting screws (A).
Step A3: Make wire connections
Connect wires as below wires connecting shown. PLEASE NOTE THAT GROUND WIRE
IS BARE COPPER WIRE, NEVER CONNECT OTHER WIRES TO GROUND WIRES.
Connect ground wire according to below chart Connect wires according to below chart
4. Check everything installed properly, then you could turn on the light. Enjoy!
CLEANING
To clean, wipe the fixture with a soft cloth. Clean glass with a mild soap. Do not use abrasive
materials such
as scouring pads or powders, steel wool or abrasive paper.
ORDERING PARTS
Keep this sheet for future reference, and in case you need to order replacement parts. All parts for this
fixture can be ordered from the place of purchase. Be sure to use exact wording from illustration when
ordering parts.