Instructions / Assembly

[e-mail]
Page: - 3 - / 3
Connect wires as below wires connecting shown. TAKE NOTE OF YOUR WIRE COLOR
OF FIXTURE ,NEVER CONNECT WIRE TO GROUND WIRE
Connect ground wire according to below chart Connect wires according to below chart
Twist plastic wire connector until wires are tightly joined together,wrap each connector with approved electrical tape.Be sure
that no wire strands are exposed and then carefully tuck all wires into the outlet box .
Step A4: Align the holes in the back plate (E) with the mounting screws, then attach the back plate (E) using
the previously removed knob nut (J). Hand tighten until snug.
Step A5: Twist the taper pipe (K) on the iron tube (I).
Fix the glass plate (F) to the iron lining (H) with screw (G).
Install bulbs (Not included. Please do not exceed the maximum capacity recommended on the
socket.)
4. Check everything installed properly, then you could turn on the light. Enjoy !
CLEANING
To clean, wipe fixture with a soft cloth. Clean glass with a mild soap. Do not use abrasive materials such as scouring pads or
powders, steel wool or abrasive paper.
ORDERING PARTS
Keep this sheet for future reference, and in case you need to order replacement parts. All parts for this fixture can be ordered
from place of purchase. Be sure to use exact wording from illustration when ordering parts.