Instructions / Assembly

[phone] Working hours : Mon - Fri 9:00 a.m. - 16:00 p.m. EST
[e-mail]
Unscrew knob nuts (F) from back plate (E), then set them aside for later installation.
Step A2: Secure mounting plate (D) to the outlet box with mounting screws (A).
Step A3: Make wire connections
Connect wires as belowwires connection shown. PLEASE NOTE THAT GROUND WIRE IS BARE
COPPER WIRE, NEVER CONNECT OTHER WIRES TO GROUND WIRES.
Connect ground wires according to the below chart
Connect wires according to the below chart
wires together with s and
4 E pre-assembled
(E) to mounting plate (D) with the previously removed knob nuts (F). Hand tighten until snug.
Note: back plate (E) should be snug against the wall with knob nuts (F). If not, remove back
plate (E), adjust the threaded length of pre-assembled mounting screws on mounting plate
assembly (D) by unscrewing the pre-assembled hex nuts and then screwing the
pre-assembled mounting screws in or out of the mounting plate until the secure length is
achieved. Tighten the pre-assembled hex nuts and back to Step A4.
5 Fix cloth shades (I) to sockets (H) with socket rings (J).
Install bulbs (Not included) (Please do not exceed the maximum wattage recommended on the
socket.)
4. Check everything is installed properly, then you could turn on the light. Enjoy!
CLEANING
the cleaner (such as mild and non-abrasive
.)
ORDERING PARTS
the
- 3 - 3