Instructions / Assembly

[phone]
Working hours : Mon  Fri 9:00 a.m.  16:00 p.m. EST
[e-mail]
Step A1: Unscrew knob nuts (F) from back plate (E), then set them aside for later installation.
Step A2: Carefully pass the supply wires from the outlet box through mounting plate (D).
Secure mounting plate (D) to the outlet box with mounting screws (A).
Step A3: Make wire connections
Connect wires as below wires connection shown. PLEASE NOTE THAT GROUND WIRE IS
BARE COPPER WIRE, NEVER CONNECT OTHER WIRES TO GROUND WIRES.
Connect ground wires according to the below chart
Connect wires according to the below chart
Twist wires together with plastic wire connectors until tightlyjoined, and wrap each connector
with approved electrical tape. Be sure that no wire strands are exposed and then carefully tuck
all wires into the outlet box.
Step A4: Align the holes in back plate (E) with the preassembled mounting screws, then attach back
plate (E) to mounting plate (D) with the previously removed knob nuts (F). Hand tighten until
snug.
NOTE: back plate (E) should be snug against the wall with knob nuts (F). If not, remove
back plate (E), adjust the threaded length of preassembled mounting screws on
mounting plate assembly (D) by unscrewing the preassembled hex nuts and then
screwing the preassembled mounting screws in or out of mounting plate (D) until the
secure length is achieved.
Tighten the preassembled hex nuts and back to Step A4.
Step A5: Unscrew socket rings (J) from sockets (H).
Fix cloth shades (I) to sockets (H) with socket rings (J).
Install bulbs (Not included) (Please do not exceed the maximum wattage recommended on the
socket.)
4. Check everything is installed properly, then you could turn on the light. Enjoy!
CLEANING
To clean, wipe the fixture with a soft cloth. Do not use abrasive materials such as scouring pads or
powders, steel wool or abrasive paper.
ORDERING PARTS
Keep this sheet for future reference in case you need to order replacement parts. All parts for this fixture
can be ordered from the place of purchase. Be sure to use exact wording from illustration when ordering
parts.
Page:  3  / 3