Instructions / Assembly

Page: - 3 - / 3
Step A1: Unscrew the ball knobs (F) from the back plate (E) then gently remove the mounting plate (D).
Step A2: Secure mounting plate (D) to outlet box with mounting screws (A).
Step A3: Make wire connections
Connect wires as below wires connecting shown. PLEASE NOTE THAT GROUND WIRE
IS BARE COPPER WIRE, NEVER CONNECT OTHER WIRES TO GROUND WIRES.
Connect ground wires according to the below chart Connect wires according to the below chart
Twist wires together with plastic wire connector until tightly joined, and wrap each connector with
approved electrical tape. Be sure that no wire strands are exposed and then carefully tuck all wires into the
outlet box.
Step A4: Align the pre-assembled mounting screws and the holes in the back plate (E), then tighten
the back plate (E) with the previously removed ball knobs (F) until snug.
Step A5: Install bulbs (Not included) (Please do not exceed the maximum wattage recommended
on the socket.)
Carefully secure the glass (J) to the cover (H) with screws (I).
4. Check everything installed properly, then you could turn on the light. Enjoy!
CLEANING
To clean, wipe the fixture with a soft cloth. Clean glass with a mild cleaner (such as mild soap). Do not use
abrasive materials such as scouring pads or powders, steel wool or abrasive paper.
ORDERING PARTS
Keep this sheet for future reference in case you need to order replacement parts. All parts for this fixture can
be ordered from the place of purchase. Be sure to use exact wording from illustration when ordering parts.
[e-mail]