User's Manual

Page31
enter in your NET setup. Example: If you enter
three phone numbers/email address then you need
to have a three minute trigger interval.
TIP: You can press and hold the ◄ or ► button to
speed through the settings rather than repeatedly
pressing the button.
TIME LAPSE: Press the ▼ and ▲ arrow to highlight
the Time-Lapse option. This option allows your
camera to automatically take a photo without being
triggered by the PIR. If you already set the
Sensitivity to OFF, then the camera will only take
photos when the Time-Lapse option is on. If you
have the PIR set to LOW, NORMAL, or HIGH, the
camera will also take photos when the PIR is
triggered. To turn the Time-Lapse option on, use
the ◄ and ► buttons to choose a time option. 5-
60 seconds (in 5 second increments) and 2-60
minutes. Once you have chosen the time option
you want, press OK to save the setting. The camera