MSDS

ManualsBrandsUPG ManualsTools & HardwareDry Charge AGM 12-Volt 12 Ah Capacity K Terminal Battery

MATERIAL SAFETY DATA SHEET

MSDS Number: 02

January 20, 2009

1. PRODUCT IDENTIFICATION

PRODUCT NAME: Dry Charged battery (for Motorcycle)

CHEMICAL FAMILY: Lead and lead components

HEMICAL NAME: Dry charged, lead-acid battery

ORMULA: Not applicable

NO.: Not applicable

elephone number: +86-571-88144451

2. HAZARDOUS INGREDIENTS

MATERIAL OR CAS# WEIGHT OSHA PEL ACGIH TLV 0SHA ACTION

COMPONENT % LEVEL

Lead and lead compounds 7439-92-1 ＜95 0.05mg/m

0.15mg/m

0.03mg/m

Antimony 7440-36-0 ＜1.1 0.50mg/m

0.50mg/m

Not applicable

Arsenic 7440-38-2 ＜0.1 0.01mg/m

0.02mg/m

0.005 mg/m

Calcium compound 7440-70-2 ＜0.1 1.00mg/m

0.50mg/m

Not applicable

Tin compound 7440-31-5 ＜0.3 2.00mg/m

2.00mg/m

Not applicable

3.PHYSICAL DATA

BOILING POINT: LEAD 3164℉(1740℃)@760 mm Hg

POLYPROPYLENE >320℉

MELTING POINT: LEAD 621℉(327.43℃)

SPECIFIC GRAVITY: LEAD 11.34

VAPOR PRESSURE (mm Hg @ 20 ℃): LEAD NEGLIGIBLE

VAPOR DENSITY: LEAD N/A

SOLUBILITY: LEAD INSOLUBLE IN WATER

%VOLATILES BY VOL.: NEGLIGIBLE

%EVAPORATION RATE: LEAD N/A

APPERANCE AND ODOR: NO ORDR. BATTERY CASE IS

BLACK OR BLACK AND

WHITE

4.HEALTH HAZAD INFORMATION

LEAD COMPOUNDS:

HAZADOUS EXPOSURE CAN OCCUR ONLY WHEN PRODUCT IS HEATED,

OXIDIZED OR OTHERWISE PRCESSED OR DAMAGED TO CREAT DUST, VAPOR

OR FUME.

ROUTES OF ENTRY:

MSDS for Dry Charged Motorcycle Batteries

Non Hazardous Ingredient 3.4 - - Not applicable

Total 100 - - Not applicable

Summary of content (5 pages)

PAGE 1
MSDS for Dry Charged Motorcycle Batteries R MATERIAL SAFETY DATA SHEET MSDS Number: 02 January 20, 2009 1. PRODUCT IDENTIFICATION PRODUCT NAME: CHEMICAL FAMILY: CHEMICAL NAME: FORMULA: UN NO.: Dry Charged battery (for Motorcycle) Lead and lead components Dry charged, lead-acid battery Not applicable Not applicable Telephone number: +86-571-88144451 2.
PAGE 2
1) INHALATION: Lead compounds: Inhalation of lead dust or fumes may cause irritation of upper respiratory tract and lungs. 2) INGESTION: Lead compounds: Acute ingestion may cause abdominal pain, nausea, vomiting, diarrhea and severe cramping. This may lead rapidly to systemic toxicity and must be treated by a physician. 2) SKIN CONTACT: Lead compounds: Not absorbable through the skin. 3) EYE CONTACT: Lead compounds: May cause eye irritation.
PAGE 3
UNUSUAL FIRE AND EXPLOSION HAZARD: Highly flammable hydrogen gas is generated during charging and operation of batteries. To avoid risk of fire or explosion, keep sparks or other sources of ignition away from batteries. Do not allow metallic material to simultaneously contact negative and positive terminals of cells and batteries. Follow manufacturer’s instructions for installation and service. 7.
PAGE 4
Lead dust should be vacuumed or wet-swept: use controls, which minimize fugitive emissions; do not use compressed air. SAFE HANDLING AND STORAGE: Store batteries in cool, dry, well-ventilated areas with impervious surfaces and adequate containment in the event of spills. Batteries should also be stored under roof for protection against adverse weather conditions. Separate from incompatible materials. Store and handle only in areas with adequate water supply and spill control. Avoid damage to containers.
PAGE 5
Place neutralized slurry into sealed containers and handle as applicable with state and federal regulations. Large water-diluted spills, after neutralization and testing, should be managed in accordance with approved local, state and federal requirements. Consult state environmental agency and/or federal EPA. 13. REGULATION INFORMATION RISK PHRASES: R20/22: Harmful by inhalation and if swallowed. R33: Cause severe burns. R58: May cause long term adverse effects in the environment.