Technical data

CLIMATE CONTROLLER C-46 - INSTALLATION AND OPERATION MANUAL
5
2Preface
The Uponor Climate Controller installation manual describes how
to install and operate the components of the system. Example
applications and possible configurations of the system are also
included.
2.1 Safety instructions
Warnings used in this manual
The following symbols are used in the manual to indicate special
precautions when installing and operating any Uponor
equipment:
Safety measures
Conform to the following measures when installing and operating
any Uponor equipment:
• Read and follow the instructions in the installation and
operation manual.
• Installation must be performed by a competent person in
accordance with local regulations.
• It is prohibited to make changes or modifications not
specified in this manual.
• All power supply must be switched off before starting any
wiring work.
• Do not use water to clean Uponor components.
• Do not expose the Uponor components to flammable
vapours or gases.
• We cannot accept any responsibility for damage or
breakdown that can result from ignoring these instructions!
Power
Technical constraints
2.2 Limitations for radio transmission
The Uponor system uses radio transmission. The frequency used
is reserved for similar applications, and the chances of
interference from other radio sources are very low.
However, in some rare cases, it might not be possible to establish
perfect radio communication. The transmission range is sufficient
for most applications, but each building has different obstacles
affecting radio communication and maximum transmission
distance. If communication difficulties exist, Uponor can support
the system with accessories, such as repeaters, for solving
exceptional problems.
2.3 Disposal
The Uponor Control System consists of various recyclable
components. Uponor would be grateful if the components
(batteries, plastics, and electric or electronic parts) are sorted and
disposed of at a suitable recycling centre.
WARNING!
Risk of injury. Ignoring warnings can cause injury or
damage components.
CAUTION
Ignoring cautions can cause malfunctions.
WARNING!
The Uponor system uses 50 Hz, 230 V AC power. In
case of emergency, immediately disconnect the power.
CAUTION
To avoid interference, keep installation/data cables
away from power cables of more than 50 V.