Install Instructions

Quik Trak® Design and Installation Manual
13
Panel Installation (cont.)
Begin the installation by laying
down the Quik Trak panels and
anchoring one side of a panel with a
screw at both ends (see Figure 14).
This allows for quick realignment,
if necessary. Once the panels are
properly placed, install screws on
both sides of a panel. Use ten screws
to ensure that the panels are secure
(see Figure 15). Using the Quik Trak
Installation Tool Kit (E6050000) will
speed this process and alleviate strain
from bending.
Installing Return Panels
When the Quik Trak installation
is finished, it is time to install the
Return Panels.
1. Place the aluminum strips in the
area where the Return Panels will
be installed.
2. Trim the aluminum strips with a
pair of tin snips as needed.
3. Place the Return Panels so they
align with the grooves in the
Quik Trak panels. Make sure
to maintain a serpentine pattern
for proper tubing placement
(see Figures 16 and 17).
4. Secure the Return Panels
into place using 10 screws.
If necessary, you can cut Return
Panels to provide 90° bends.
5. When Return Panels are in place,
secure the half-moon wood
pieces with a single screw to
guide tubing turns.
Figure 14: Anchor One Side of a Panel
Figure 16: Correct Panel Placement for Serpentine Pattern
Figure 15: Fasten Panels with 10 Screws
Figure 17: Incorrect Panel Placement