Installation and Operation Manual

4 Install Uponor Smatrix Wave PULSE

4.1 Installation procedure

Uponor recommends following the process described below to

guarantee the best possible installation results.

1. Prepare for installation, Page 16

2. Install Uponor Smatrix Wave PULSE room controller, Page 21

3. Install antenna or communication module (contains an antenna).

• Install room controller antenna, Page 23

• Install communication module, Page 24

4. Connect optional expansion module, Page 22

5. Install Uponor Smatrix Wave room thermostat, Page 34

6. Finishing installation, Page 74

4.2 Prepare for installation

• Verify the contents of the package with the packing list.

• Study the wiring diagram in the installation and operation manual

or inside the room controller cover.

• Ensure that the room controller can be installed close to the

manifold. Note that each manifold must have its own room

controller.

• Ensure that the room controller can be mounted close to a 115 V

AC wall outlet, or if required by local regulations, to a junction

box, connected to the mains power.

• Ensure that installed Uponor Smatrix components are protected

from running or dripping water.

Uponor Smatrix Wave PULSE

Installation and operation manual