Installation and Operation Manual

5.2 Connect optional expansion

module

SI0000023

Note

Only one expansion module extension is supported per

room controller.

Snap the slave module to the room controller (recommended to do

this on a flat surface or on a DIN-rail).

Remove the expansion module

1.2 mm

8 mm

SI0000094

SI0000095

1. Place a wide flat head screwdriver in the slot between the slave

module and the other unit and twist until the snap-in lock

releases. Repeat for the other side.

2. Remove the expanion module. Use caution not to bend the

connection pins.

5.3 Attach room controller to the

wall

Attach the room controller to the wall using a DIN-rail and/or screws

and wall plugs.

Using DIN rail

SI0000008

Caution!

Make sure the room controller cannot slide off the DIN

rail if mounting it in any other position than horizontal.

1. Fasten the DIN rail to the wall using the screws and wall plugs.

2. Snap the room controller to the DIN rail.

Remove from DIN rail

SI0000093

1. Use a screwdriver (or similar) and extend the plastic spring

catch from the room controller.

2. Angle the room controller from the wall.

3. Remove the room controller from the DIN rail.

Uponor Smatrix Wave PULSE

Installation and operation manual