Installation and Operation Manual

6 Install Uponor Smatrix Wave room
thermostat
6.1 Uponor Smatrix Wave T-161
Placement of thermostat
1.3–1.5 m
SD0000002
• Select an indoor wall and a position 1.3 m to 1.5 m above the
floor.
• Ensure that the thermostat is away from direct sunlight.
• Ensure that the thermostat will not be heated through the wall by
sunshine.
• Ensure that the thermostat is away from any source of heat, for
example television set, electronic equipment, fireplace,
spotlights, and so on.
• Ensure that the thermostat is away from any source of humidity
and water splashes (IP20).
• Ensure that the thermostat is positioned at least 40 cm away
from the room controller to avoid interference.
Label thermostat
#01
#01
SI0000061
Label the thermostat, where suitable, with the channel numbers they
are to control, for example, #02, #03. For a system with several room
controllers, add the ID of each room controller, for example, 1.02,
1.03, 2.02, 2.03.
If an external sensor is connected, add information about sensor type
when applicable.
Available thermostat and sensor combinations:
• Room temperature
• Room and floor temperature
Connect external sensor to thermostat
1
2
3
SI0000045
Note
For accurate temperature: attach the outdoor sensor to
the north side of the building where it is unlikely to be
exposed to direct sunlight. Do not place it close to doors,
windows, or air outlets.
Caution!
If more than one hour has passed between startup of the
thermostat, and the sensor being inserted. Remove the
battery from the thermostat, wait 30 seconds and reinsert
the battery again. The thermostat will now be configured
with a floor sensor
.
1. Remove the breakout plastic on the back of the thermostat.
2. Press the push buttons on the connection terminals.
3. While pressing the push buttons, insert the two wires from the
sensor cable (non polarized) into the connection terminal.
The external temperature sensor input can be used to connect a floor
temperature sensor. Thermostat control mode for the T-161 is set
when a floor sensor is connected to the thermostat.
34
|
Uponor Smatrix Wave PULSE
|
Installation and operation manual