Installation and Operation Manual

Start the thermostat

SI0000104

Remove the plastic transportation strip from the battery to start the

thermostat.

The thermostat use a single CR2032 3V button cell lithium battery

which provides about 2 years of battery life, as long as it is positioned

within radio range of the room controller. Ensure that the battery is

correctly inserted in the thermostat.

The thermostat will perform a self test, for about 10 seconds, when

starting up. The system will be blocked for input and the thermostat

LED flashes during this period.

Attach thermostat to the wall

CD0000005

The thermostat is delivered in a kit with screws, wall plugs, and a wall

bracket, presenting several options of attaching the thermostat to the

wall.

Wall bracket (recommended)

38 mm

SI0000021

Attach the thermostat to the wall using the wall bracket, screws and

wall plugs.

Screw and wall plug

38 mm

SI0000022

Attach the thermostat to the wall using the screw and wall plug.

Adhesive strip

22 x 24

SI0000020

Attach the thermostat to the wall using the wall bracket and adhesive

strips.

1. Enter registration mode

3 s

SI0000065

Press and hold the OK button on the room controller until the LED for

channel 1 (or the first unregistered channel) flashes red.

2. Select a channel

SI0000070

1 65432

Use buttons < or > to move the pointer (LED flashes red) to a

preferred channel.

Uponor Smatrix Wave PULSE

Installation and operation manual