Installation and Operation Manual

6.2 Uponor Smatrix Wave T-169

Placement of thermostat

1.3–1.5 m

SD0000002

• Select an indoor wall and a position 1.3 m to 1.5 m above the

floor.

• Ensure that the thermostat is away from direct sunlight.

• Ensure that the thermostat will not be heated through the wall by

sunshine.

• Ensure that the thermostat is away from any source of heat, for

example television set, electronic equipment, fireplace,

spotlights, and so on.

• Ensure that the thermostat is away from any source of humidity

and water splashes (IP20).

• Ensure that the thermostat is positioned at least 40 cm away

from the room controller to avoid interference.

Label thermostat

#01

SI0000062

Label the thermostat, where suitable, with the channel numbers they

are to control, for example, #02, #03. For a system with several room

controllers, add the ID of each room controller, for example, 1.02,

1.03, 2.02, 2.03.

If an external sensor is connected, add information about sensor type

when applicable.

Available thermostat and sensor combinations:

• Room temperature

• Room and floor temperature

• Room and outdoor temperature

• Remote sensor temperature

Uponor Smatrix Wave PULSE

Installation and operation manualUponor Smatrix Wave PULSE

Installation and operation manual