Installation and Operation Manual

Note

It is recommended to register at least one room

thermostat before registering a system device.

Note

Make sure all components are connected to the relay

module before registering.

2. Move the channel pointer to the power LED

SI0000082

Use buttons < or > to move the pointer to the power LED (LED

flashes red).

3. Enter system device registration mode

SI0000083

Press the OK button to enter system device registration mode (power

LED). The power LED starts flashing according to the pattern long

blink, short pause, long blink. Channel 1 starts flashing red.

4. Select a channel

SI0000080

1 65432

Use buttons < or > to move the pointer (LED flashes red) to channel

5. Lock selected channel

SI0000071

Press the OK button to select the channel for registration. The LED

for the selected channel starts flashing green.

6. Power up the relay module

SI0000040

Power up the relay module and count the number of flashes of LED 2

(blue) to ensure it is in normal run mode.

LED 2: 1 flash = Normal (default)

LED 2: 2 flashes = Two stage additional cooling

Change relay module run mode

SI0000041

1. Power down the relay module and wait about 10 seconds.

Press and hold the button on the relay module while turning it on

again.

LED 2 flashes once (Normal run mode).

SI0000081

Press and hold the register button on the relay module until the LEDs

on the module start flashing slowly.

The selected channel LED in the room controller turns fixed green

and the LEDS on the relay module start flashing fast again, to turn off

a few seconds later.

Uponor Smatrix Wave PULSE

Installation and operation manual

24VAC