Installation and Operation Manual

Press and hold the OK button for about 3 seconds to exit the settings
menu.
Register to a T-169 thermostat
1. Enter relay module registration mode
SI0000127
Press and hold the register button on the relay module until the LEDs
on the module start flashing slowly
.
5. Register thermostat to relay module
YES
09
SI0000155
Use buttons or to change Int no to Int CNF.
49
|
Uponor Smatrix Wave PULSE
|
Installation and operation manual
2.
Enter settings menu
3 s
SI0000114
Press and hold the OK button for about 3 seconds. The settings icon
and menu numbers is displayed in the top right corner of the display.
3. Locate menu 09
09
SI0000123
Use buttons or to change the numbers to 09. The text Int no is
displayed.
4. Enter parameter edit mode
NO
09
SI0000124
Press OK to enter parameter edit mode (the parameter starts
flashing).
6. Registration
CNF
09
NO
09
SI0000125
The connection indicator is shown in the thermostat display to show
that the registration process begins.
The text Int YES is shown in the thermostat display and the LEDS on
the relay module start flashing fast again, to turn off a few seconds
later.
7. Confirm registration
SI0000118
Press OK to confirm the parameter change.
8. Exit settings menu
3 s
SI0000119
Press and hold the OK button for about 3 seconds to exit the settings
menu.