Installation and Operation Manual

07 Cooling allowed
In this menu it is set whether cooling is allowed in the room or not.
This menu is not visible if a communication module is connected to
the system. The setting is then available in the Uponor Smatrix
PULSE app.
See Change settings, Page 90, for how to change the setting.
Uponor Smatrix Wave T-166
Uponor Smatrix Wave T-169
Symbol Description
Shows the cooling demand icon
Hides the cooling demand icon
08 Display unit
In this menu temperature display unit is set.
See Change settings, Page 90, for how to change the setting.
Uponor Smatrix Wave T-169
Symbol Description
Degrees Celsius
Degrees Fahrenheit
09 Climatic controller integration
In this menu it is set whether the thermostat also should be
integrated, and share temperature data, with an Uponor Smatrix
Move supply controller
.
This menu can also be used when registering the thermostat to a
relay module. Using the relay module to control distributed manifolds.
Default value: no
See Change settings, Page 90, for how to change the setting.
Uponor Smatrix W
ave T-169
Symbol Description
Not integrated
Integrated (requires to be registered with the Move
supply controller first)
Register with the Move supply controller/relay
module, confirm on the Move supply controller/relay
module
65
|
Uponor Smatrix Wave PULSE
|
Installation and operation manual
11 Room temperature calibration
Default: 0.0 ˚C
Setting range: -6.0 – 6.0 ˚C, 0.1 ˚C increments
In this menu the room temperature shown in the thermostat display
can be calibrated.
See Change settings, Page 90, for how to change the setting.
12 Invert screen (T-169 only)
In this menu the colour in the display can be inverted.
See Change settings, Page 90, for how to change the setting.
14.6 Replace batteries
Uponor Smatrix Wave T-161
Replace the battery of the thermostat when the LED flashes (once
every two hours).
The thermostat will perform a self test, for about 10 seconds, when
the battery have been inserted. The system will be blocked for input
and the thermostat LED flashes during this period.
3
1
2
SI0000189
To change the battery:
1. Remove the thermostat from the wall.
2. Use a pointed object to remove the battery.
3. Replace the battery.
is
Uponor Smatrix W
ave T-169
Replace the battery of the thermostat when the low battery icon
shown in the display (alarm list).
3
1
2
SI0000192
To change the battery:
1. Remove the thermostat from the wall.
2. Use a pointed object to remove the battery.
3. Replace the battery.