Installation and Operation Manual

Components of the thermostat:
The illustration below shows the thermostat and its components.
A
B C D E
CD0000031
Item Description
A Uponor Smatrix Wave T-161
B Wall bracket
C Adhesive tape
D Battery (CR2032 3V)
E Mounting hardware
Uponor Smatrix Wave PULSE
|
Installation and operation manual
|
9
Uponor Smatrix Wave T-169 digital thermostat
The thermostat shows the ambient, set temperature, or relative
humidity on the display. Temperature settings are adjusted using /
buttons on the side of the thermostat.
Main characteristics:
• Power saving e-paper display (updates every 10 minutes).
• Displays Celsius or Fahrenheit.
• Operative sensor for increased comfort.
• Calibration of displayed room temperature.
• Heating/cooling demand as well as low battery indication on
display.
• Displays Uponor logo and software version during power up
sequence.
• Setpoint range is 5 – 35 °C (maximum and minimum setting may
be limited by other system settings).
• Room temperature regulation with use of optional external
temperature sensors.
• Displays optional temperature sensor values if sensors are
connected and relevant room temperature regulation is
activated.
• Switch between Comfort and ECO mode with scheduling
(requires Uponor Smatrix PULSE app).
• Adjust ECO setback value.
• Relative humidity limit alarm indicated in display (requires
communication module).
• Invert display color.
• Can be placed up to 30 meters away from the room controller.
Components of the thermostat:
The illustration below shows the thermostat and its components.
A
B C D E
CD0000027
Item Description
A Uponor Smatrix Wave T-169
B Wall bracket
C Adhesive tape
D Battery (CR2032 3V)
E Mounting material
Expansion module
The Uponor Smatrix Wave room controller can be expanded with six
extra channels and actuator outputs using a Slave module.
Uponor Smatrix Wave M-262
Note
Only one slave module extension is supported per room
controller
.
Main characteristics:
• Easy plug in installation on existing room controller, no additional
wiring needed.
• Register up to six extra thermostats to the system.
• Connect up to six extra actuators (24 V).
• Electronic control of actuators.
• Valve exercise.
Components of the slave module
The illustration below shows the slave module and its components.
A B C
CD0000033
Item Description
A Uponor Smatrix Wave M-262
B DIN rail
C Mounting material
Relay module
The relay module adds two extra output relays to the system.
Uponor Smatrix Wave M-161
Main characteristics:
• Potential free contacts (24 VAC, 5 A).
• Requires an Uponor Smatrix Wave room controller.
• Pump control and heating/cooling output function.
• Pump and dehumidifier control function (requires communication
module and Uponor Smatrix PULSE app).
• Boiler and chiller control function (requires communication
module and Uponor Smatrix PULSE app).
• Comfort/ECO and ventilation control function (requires
communication module and Uponor Smatrix PULSE app).
• Fan coil control (requires communication module and Uponor
Smatrix PULSE app for the fan coil to be linked to a room
channel).
• Optional two stage cooling function (requires activation on the
relay module, and the communication module).
See Use relay module for time delayed two stage additional
cooling (requires communication module), Page 68 for more
information.
• Can be placed up to 30 meters away from the room controller.