Installation manual

Uponor Control System - Installation Manual 11

3.4.1 Mark room thermostats

3.4.2 Insert batteries

3.4.3 Register room thermostats

Example of registration: thermostat placed in a room, with

3 loops connected to channels 02 and 03.

• Type of batteries for the thermostats:

2x Alkaline AAA 1.5V. Respect the polarity.

• Mark the thermostats with the channel numbers

they are to control e.g. 02, 03. For a system

with an interface and several controllers the ID

of the controller has to be added e.g. 1.02,

1.03, 2.02, 2.03.

See: controller Operation Manual

Press the Test push-button

➜

The Test LED lights up .

Press the push-buttons of channels 02 and 03

➜

The LED of channels 02 and 03 flash .

Using a point, press the registration button of the

thermostat for at least 5 seconds.

For Thermostat Display T-75:

• The temperature is replaced by 2 lines

• When the temperature appears again the button

can be released

For Thermostat T-55 and Thermostat Public T-53:

• The LED of thermostat blinks one time only

➜

If registration is successful the LEDs of channels 02

and 03 switches on after 10 s

If channel registration fails (the channel LEDs

continues to flash or switch off), follow steps 2 to 4

once more.

Press Test push-button to end the registration process

➜

The Test LED switch off

LED LED status

LED on

LED flash

LED off

To cancel registration of a channel and to reset the

controller: see: "3.9 Resetting", page: 17.

Wrong registration of the channels will cause bad

temperature control.