Installation manual

14 Underfloor Heating
3.4.5 Thermostat setup
3.4.6 Mark the external sensor thermostats
3.4.7 Insert batteries
3.4.8 Connect the sensor and put switch on right
position
3.4.9 Register external sensor thermostats
3.4.10 Cancelling the registration of a channel
3.4.11 Mount external sensor thermostats
3.4.12 Set min and max temperature for floor sensor
3.4.13 Close the thermostats
3.4.14 Carry out communication test
3.5 External sensor thermostats
3.5.1 Introduction
The Thermostat Public T-53 allows a floor or outdoor sensor
to be fitted to the system.
Configuration switches
The Thermostat Public T-53 has a terminal to permit the
connection of different type of sensors.
The switches has to be set according to the type of sensor
used.
3.5.2 Registration and marking
See Operation Manual for thermostat min/max and
room temperature settings.
99
For more information on external sensor settings:
See: "3.5 External sensor thermostats", page: 14.
99
See: "3.4.1 Mark room thermostats", page: 11.
See: controller Operation Manual.
99
See: "3.5 External sensor thermostats", page: 14.
99
See: "3.4.3 Register room thermostats", page: 11.
99
See: "3.9 Resetting", page: 17.
99
See: "3.5 External sensor thermostats", page: 14.
See: "3.5.4 Floor sensor setting", page: 15.
See: controller Operation Manual, page: 10.
99
See: "3.6 Testing the communication between the
thermostats and the controller", page: 16.
Floor sensor
Outdoor sensor
(No used)
(No used)
Only one of the four switches must be on. When the
thermostat is used as a room thermostat all
switches should be off. If more than one switch is
on: the LED flickers. It stops flashing when only one
switch is on, or none at all.
99
The registration procedure for a Thermostat
Public T-53 fitted with a floor or outdoor sensor is
similar as that followed for room thermostats. See:
"3.4.3 Register room thermostats", page: 11.
Marking the Thermostat Public T-53 is carried out in
the same way as with the room thermostat, but
add information floor or outdoor.
See: "3.4.6 Mark the external sensor thermostats",
page 14.
1
2
3
4