Installation manual

Uponor Control System - Installation Manual 17

3.9 Resetting

3.9.1 Cancelling the registration of a channel

3.9.2 Resetting the system

If there are problems with thermostat linking, thermostats

mixed up, bad channel registration, etc, the system can be

reset.

• For the controller, press the Test button for 10 s. The

Test LED flashes for at least 2 s, then all LED go off

(except the POWER LED). All parameters are erased.

New installation / registration after reset is necessary.

• Pressing briefly the reset buttons is sufficient for the

thermostats. New installation / registration after reset is

not necessary.

Press the Test push-button

➜

The Test and channel LEDs with registered

thermostats light up .

Press the push-button of the channel that is to be

cancelled for 10 s

➜

The LED of the channel cancelled flashes for 2 s

then switches off .

Press the Test push-button to leave registration mode

➜

The Test LED switches off .

STOP

In order to register a different thermostat to a

channel, you first have to cancel the existing, not

desired registration of this thermostat.