Installation manual

55 Uponor Control System - Operation Manual 5
2. The Uponor Control System
The Uponor Control System is a complete management for
underfloor heating systems. Comfort, user-friendliness and
temperature control for each room can be combined through
the different components. The controller Installation and
Operation Manual allow an optimum installation and setting.
An ergonomic interface can be added in order to facilitate the
setting and optimize the management. If your system is
equipped with an interface, see interface Installation and
Operation Manual.
2.1 Overview of the system
The controller manages the operation of the actuators, when
required by the thermostats following a demand for heating
or cooling. It is possible to add an interface to centralize and
optimize the management of the system.
The Uponor Control System may be controlled with the help
of three types of thermostats. Designed for maximum
comfort, the thermostats communicate with the controller
through radio waves. They may be used individually or in
combination with each other. They are fitted with the same
battery type for power supply.
Thermostat Display T-75
The thermostat shows the ambient or set
temperature on its screen.
The thermostat is designed for operative
measurement, it is affected by temperature of
surrounding surfaces as well as the ambient air
temperature.
1
Thermostat T-55
The thermostat is easy to use.
The temperature settings can be adjusted with
the help of a simple dial. The cover may be
removed to allow min/max temperatures to be
set.
The 21°C position is marked.
Thermostat Public T-53
The thermostat is designed for public location.
An alarm is triggered as soon as the cover is
opened.
The button, switches and potentiometers are
all hidden by a cover. The cover may be
removed to allow min/max temperatures to be
set.
An external sensor can be connected.
Controller with antenna and actuators
The controller drives the actuators according to the setting
in the interface and the temperature information received
from the thermostats.
The controller is typically located near the hydraulic system
manifolds.
Interface I-75
(possible option)
The interface gives you the opportunity to
centralize and optimize the management of the
system. The interface allows you to display and
update easier and faster the operating
parameters of the system.
The interface also displays the causes of any
alarms. It is simple and easy to use.
2
3
4
5