Instructions / Assembly

Enclosure Pole User Manual

Manufactures note:

 Before starting installation process please verify that you have the same amount of poles to match your legs, or that you have

two poles per leg.

 Please have your trampoline leg measured in diameter to verify that it measures 1.5” to match the larger hole of the clamp.

WARNING: 2 adults in good physical condition are required for the following assembly. Wear proper shoes and maintain

balance to prevent a fall. Failure to follow all instructions and warnings exactly may result serious injury.

1. Place all parts to be used in

process of installation in front of

you.

4. Be aware that the mark on the lower pole needs to

align with the trampoline frame. If there is no line on the

pole then please have it attached 18” below the frame.

3. Once the pole is securely inserted

into the clamp you can now clasp the

leg into the larger hole of the clamp.

2. Making sure that the black plastic

of the lower pole faces down. Take

the clamp and clasp the trampoline

pole into the smaller hole of the 8-

Shaped Pole Clamp (serves as the

pole and leg connecter).

PAGE 1
Enclosure Pole User Manual Manufactures note:   Before starting installation process please verify that you have the same amount of poles to match your legs, or that you have two poles per leg. Please have your trampoline leg measured in diameter to verify that it measures 1.5” to match the larger hole of the clamp. WARNING: 2 adults in good physical condition are required for the following assembly. Wear proper shoes and maintain balance to prevent a fall.
PAGE 2
6. Feed the screw through the screw hole thus tightening the clamp to securely connect it to your trampoline leg. 5.The set comes with 2 clamps per pole. One being attached 2” below frame, while the other being attached 2” above the end of the lower pole. 7. Now you can have the upper part of the pole inserted into the lower part that is already attached to the leg. 8. If your trampoline net attaches with straps it is advised to use the pole caps with a c-shape on it.
PAGE 3
9. If your trampoline uses a sleeve type net it is advisable to use the round pole caps, which is installed before putting on the net. 10.Place the pole cap onto the upper pole. 11.Repeat the steps above to have all your enclosure poles connected securely to your trampoline legs. Upper Bounce has to offer a large array of other trampoline parts, please feel free to contact us at: 1-845-810-0083 or email us at: info@upperbounce.