TABLE ASSEMBLY INSTRUCTIONS —
TABLE ASSEMBLY Illustrations may appear slightly different depending on the model of desk ordered.
If the table is longer than 96” the framework will include: 2X End Legs 2X Dogbone Fit Packs 1X Mid Leg OR 4X Rails 2X Table Tops
1 To assemble the frame, stand the legs upside down on the floor as shown so that the feet stick in the air. Push the rails to either side of the leg jaws. Untighten the countersunk screws to widen the jaw to fit the rail inside. Push the rail inside the jaw and retighten the screws to fit in place. Repeat for the other leg. 2 The completed framework can be flipped over onto its feet.
3 Place the top onto the framework as shown (get a partner to help). Using the M6x35mm Caphead bolts provided with the leg pack screw through the rails and into the inserts inside the top. This will fix the top in place. If necessary slide the legs further into the center of the table so that the feet do not stick out.