User Manual

In case of an empty cylinder, the DL EMPTY led will switch on

In case of a fault, DL FAULT will switch on

By opening the cylinders doors, in addition to the DL TAMPER led switching on, the relay will switch

Maximum applicable power on the outputs is 100mA

D - Example of connection FAST 02-03 outputs with inputs of an antitheft normally opened with diods (1N4148)

needed only with some equipments.

The UR Fog outputs are normally

opened and connected with input zones

of the alarm control panel opened.

According to the diagram above:

when there is an empty cylinder the

entrance area L3 will detect an alarm;

if a failure occurs or the batteries run

down, L2 detects an alarm;

when you open the door of the

cylinders, L1 detects an alarm.

E - Examples of connections FAST 02-03 outputs with balanced inputs of an antitheft

In this diagram, putting the resistance value required by the alarm control panel used in the terminal UR Fog, with

not used outputs the central will see the correct resistance, while following the activation of an output, you will

have a pull-down causing the alarm of the corresponding zone.

+12V INPUT

GND INPUT

ARM INPUT

SHOOT INPUT

GND

EMPTY OUT

FAULT OUT

TAMPER OUT

GND OUT

CENTRAL ALARM