User Manual

HOW TO ACTIVATE THE SYSTEM

It is necessary to take away the cylinders to remove the blocks placed in the upper part of the

cylinders, they are only used to avoid the risk of discharge of the liquid during transport.

It is always recommended to affix the Fast 02 or Fast 03 on a wall even when is placed on a flat surface.

Always verify that the bracket or the support surface are suitable for the weight of the machine.

It is suggested not to install the machine behind walls in a limited close area without a specific ventilation

to prevent a possible overheating.

After removing the machine from the package, unscrew the two screws that stop the right side panel and

remove it. Inside it is possible to see the front part of the electronic circuit, later called PCB.

On the side you can see two cylinders (one for Fast 03 1C) placed on the cylinder plate.

The cylinders supplied with the equipment are intended to be used only for a vertical (standard)

installation. In case of horizontal installation, please refer to your authorized reseller/distributor to

get the appropriate cylinders.

On the rear of the cabinet you have to remove precutted holes on the metal case and choose the proper ones after deciding

for a straight or corner installation.

The round precutted holes on the other hand, are to be used for cables that should go in or out of the machine.

FUSE

J11

J15

S1 S2

J13

ARM

FAUL

EMPTY

RESERVE

HEATING

ENGIME

CYLINDER

DOOR SCREW