Use and Care Manual

www.urbanwoodcraft.com - toll free: 1.855.738.1378
Door Preperation
Remove the pre-threaded bolts from the Top Roller.
Thread the bolt through the pre-drilled holes in the
Door along with the Top Roller ensuring you have
washers on either side of the assembly.
Use Wrench to tighten bolt to nut, do not over
tighten.
Pre-drill two small holes on the top of the
door near the Rollers to prepare installation of
the Anti-jump Blocks. The positon of these
holes should be offset from the center core of
the door. Refer to figure 1.1
Install the Anti-jump Blocks by screwing into
your pre-drilled holes.
Keep these blocks swung outward as you
will need them in this positon while hanging it
onto the rail.
page 04
Barn Door - Installation Guide
fig. 1.1
(v. 0.4.092517)