Use Instructions

44
interface and prepare the reagent strips and
samples for use.
2) Prepare some blotting papers at hand for
later use.
Used for remove the excess samples from the
reagent strips.
3) Soak the reagent strip in the sample.
Caution
1. Be sure to make sure all the reagent strips
are soaked in the sample. If the reagent block
was not fully soaked, some of the items could
not get the accurate test results.
2. The reagent strip should be soaked for
approximately 2 seconds. If the immersion time
is too short, the reagent strip can not be fully
colored. On the contrary, too long time will
cause the reagent component to flow out, thus
the accurate detection results can not be
obtained.