Installation Manual

4
DS1083-127
3. Remove the terminal strip cover.
2
1
3
4. Connect the assembly to the system.
The end of a stranded conductor must
not be consolidated with mild soldering
in the points in which the conductor is
subject to contact pressure.
5. Carry out the device confi guration by means of
jumpers and/or dip-switches.
6. Replace the terminal strip cover.
7. Power on the device.
8. Complete the confi guration of the parameters
as shown in the introduction.
The Urmet CallMe App confi guration
manual is available on the www.urmet.
com website or by scanning the QR
code at the end of the section.
3.2. WALL MOUNTING WITH
THE KIT REF. 1083/88
1. Fix the base of the container (supplied in the kit)
to the fl ush-mounting box mod. 503 or Ø 60mm
(2.36”) as shown in the following fi gures:
n. 2 M3.5 x 19 mm
supplied
Box Mod.503 -
horizontal
n. 2 M3.5 x 19 mm
supplied
Box Mod.503 -
vertical
n. 2 2.9 x 13 mm with
countersunk head
Box
Ø 60 mm / 2.36''
or, alternatively, with screws and anchors supplied
in the kit.
Ensure cables are led through the left
side.
2. Remove the 2 covers from the device.
2
1
3