Instructions

11
DS1723-024
EXPORTING YOKIS BUTTONS TO A REMOTE CONTROL OR VIDEO DOOR PHONE
The confi guration of the eight Yokis buttons can be exported to a Yokis eight-button remote control or to another
video door phone.
Selecting this item will automatically launch a Wizard.
RESETTING ALL ACCESS POINTS TO THE RADIO BUS
An access point can be used to control a specifi c remote receiver (or also more than one), positioned on Radio
Bus.
More information can be found in the Yokis ‘Radio Quick Installation Guide’, in ‘E: Range Extension with Radio
Bus’ and ‘E-1: Defi nition of an Access Point to the Radio Bus’.
This option can be used to delete simultaneously all the access points of all buttons of the video door phone. Run
M 24 .
SETTING THE ALARM FUNCTION
The alarm function can be set to:
Detect the opening of a door (e.g. the front door).
Detect the energising of a motion sensor.
The occurrence of any one of these two events generates an alarm sequence.
Connect a Normally Closed (N.C.) magnetic sensor to the SP terminals of the door unit in order to detect the
opening of a door near the input.
Also, check that dip-switch 1 is in the OFF position (default).
(5)
Door sensor
(N.C.)
Connect a Normally Closed (N.C.) magnetic sensor to the AL terminals of the master video door phone in order
to detect the opening of a door near the video door phone.
Door sensor
(N.C.)
—
—
(5) The alarm function cannot be used if the ‘LETTERBOX’ function is programmed (dip-switch 1 in the ON
position): the two functions are mutually exclusive.