Installation Instructions
3
A
+
C
C
A1
+
A2
B
C
B
Pair the wireless, batteryless switch to your connected installation.
Make sure that the indicator lights on the wired products are green and not flashing.
If not, go back to step
1
.
2
A1
B
C
A2
To complete your installation, briey press the congu-
ration of the Module Control or the middle of the wire-
less Home / Away master switch.
All the indicator lights on the products switch o
Complete the installation
3
< 1 s
Or
< 1 s
+
If necessary, erase the conguration of the wireless
batteryless control (factory reset)
While holding the "setup" button on the wireless batteryless
control, press the "Home" button for 5 seconds.
Conrm that your control is correctly reset by making an
"Home" command, then "Away"
5 s
Tap 3 times any wired product "with Netatmo" with the wireless, batteryless "Home/Away control". The light of the wired
product flashes rapidly.
For the specific case of the latching relay, press the main button of the latching relay until the configuration indicator
flashes slowly in blue, release it then tap it 3 times with the wireless, batteryless "Home/Away control". The indicator light
of the wired product flashes rapidly.
While holding the "setup" button on the wireless, batteryless control, briefly press the "Home" or "Away" control on the
wireless batteryless control.
The indicator light of the wired product will briefly turn blue, and then will turn green again.The pairing was successful.
Complete the configuration of the scenarios using your HOME + CONTROL application, menu "Settings", then
"Scenarios"