Installation Instructions

3
B
+
C
A
1
+
A2
B
C
To complete your installation, briey press the congu-
ration of the Module Control or the middle of the wire-
less Home / Away master switch.
All the indicator lights on the products switch o.
Complete the installation
3
< 1 s
Or
< 1 s
+
If necessary, erase the conguration of the wireless
batteryless control (factory reset)
While holding the "setup" button on the wireless batteryless
control, press the "1" or "3" button for 5 seconds.
Conrm that your control is correctly reset by making an
"1", "2", "3" or "4" command.
5 s
A1
B
C
A2
Pair the wireless, batteryless switch to your connected installation.
2
Make sure that the indicator lights on the wired products are green and not flashing.
If not, go back to step
1
.
Tap 3 times any wired product "with Netatmo" with the wireless, batteryless "4 scenes control". The light of the wired
product flashes rapidly.
For the specific case of the latching relay, press the main button of the latching relay until the configuration indicator
flashes slowly in blue, release it then tap it 3 times with the wireless, batteryless "4 scenes control". The indicator light
of the wired product flashes rapidly.
While holding the "setup" button on the wireless, batteryless control, briefly press one of the 4 buttons on the
wireless batteryless control.
The indicator light of the wired product will briefly turn blue, and then will turn green again.The pairing was
successful.
Complete the configuration of the scenarios using your HOME + CONTROL application, menu "Settings", then
"Scenarios"