User Manual

Front panel

1 .Gain The gain control adjusts the input sensitivity of the Mic and line inputs on the

input channels.

2 .High allow you to controls the Hi-range of signals 10KHz 12dB

3 .Mid allow you to controls the Mid-range of signals 2.5KHz ( 12dB)

4 .Low allow you to controls the Bass-range of signals 100Hz ( 12d B)

5 .EFF use this controls when you want to get effect sound by adjustment of input signal

6 .Pan The Channel Pan positions the output of the channel in the stereo field of the main

mix. It's constant-power design ensures there are no level discrepancies whether a signal

is hard-panned, center-stage, or somewhere in between.

7 .Level allow you to adjusts channel signal level to be sent to the master

8 .Line balanced and unbalanced 1/4 (6.35mm).diameter stereo jack input socket for

connection of high level sound sources.

9 .Mic neutrik electronically balanced XLR connector input socket. For connecting low level

signal sources. Such as microphones or other low impedance devices.

10.MP peak LED The peak LED illuminates when a amplifier output signal is going into

overload. It detects the peak level on the AMP output and will light at approximately 1dB

before clipping to warn that the signal is approaching overload. You do not want the peak

LED to light expect very intermittently during a take or a mix. If it does light persistently,

reduce input gain to protect your speakers.

11.High allow you to controls the Hi-range of the master output signals 10KHz 12dB

12.Mid allow you to controls the Mid-range of the master output signals 2.5KHz ( 12dB)

13.Low allow you to controls the Bass-range of the master output signals 100Hz ( 12d B)

14.Volume It allow you to adjust the master output level.

15.Time It allow you to adjust the delay time of the effect.

16.Depth This pose allow you to control the echo repeat depth of the effect.

17.EEF Volume this pose allow you to control the effect level to the master output.

18.Tape this pose allow you to adjust the level of the tape input to master bus.

19.Send 1/4 jack connector, output level control by EFF(5)

20.Rerturn 1/4 jack connector, allowing the output of the remote effect device to be connected to

the mixer.

21/22.Tape in RCA connector, allow you to input high level signal such as TAPE, CD.

23/24.REC output RCA connector can be used to connect the mixer to the record input of your

recorder enabling you to record your mix.

REAR PANEL:

1. Power switch please make sure that all the volume pose set on the mix position when you

want to turn on this unit, the power LED will be light when you turn on the power switch

2. Voltage selector before plugging in the power cord, make sure that the voltage selector

Switch is set to the connect voltage

3. Power connector with fuse molder

This standard IEC power cord receptacle is used to connect the AC power to your unit

4. Right speaker output

One 1/4 (6.35mm) jacks for you to connecting a speaker cabinet, the min impedance is 4 ohms.

5.Left speaker output

One 1/4 (6.35mm) jacks for you to connecting a speaker cabinet, the min impedance is 4 ohms.