Instruction manual

LCD INSTRUCTION
7
1. TOTAL TRACK – the track number of the CD or CARD.
2. –
The unit is in playing.
3. –
The unit is paused
4. SINGLE – Shows when the unit is set to play only one track.
5. CONT – Shows when the unit is set to play the all tracks continually.
6. OUTRO – Shows when the unit is set to play the last 30 seconds of each track.
7. MP3 – Lights up when the unit is playing MP3 file.
8. TIME MODE (ELAPSED) – Shows the time as it is taking place.
9. TIME MODE(TOTAL) – Shows how much time is left on full CD,
but not for MP3 CD
.
10. TIME MODE (REMAIN) – Shows how much time is left on
a particular track
.
11. –
A1 lights up after setting up start point(A point).
A1 and
flash after setting end point (B point) and start
the loop playback automatically. A1 and light up after exiting the
LOOP playback and in performance
.
12. –
Refer to SEAMLESS LOOP A1.
13. TIME BAR – Show the time length depending on the setting
of the “TIME” mode
.
14. TRACK – Shows the track number that is playing.
15. MINUTES – Shows the minutes elapsed or remaining depending on
mode setting
.
16. SECONDS – Shows the seconds elapsed or remaining depending on
mode setting
.
17. FRAMES – The CD Player breaks down a second into 75 frames
for accurate cueing. This shows the frames elapsed or
remaining depending on mode setting
.
18.EFFECT MODE DISPLAY – Shows the effect name selected in
effect parameter setting mode and shows the song name in
performance
.
19. THE PARAMETER OF SOUND EFFECT
20. PITCH – The pitch change range
21. KEY – Lights up when key effects are active and indicates
key position, otherwise it flash
.
22. –
Lights up when key has been locked.
23. BPM: Manual ; BPM : Auto
24. Number of Beat per minute
25. CARD • – Lights up when the unit is reading SD card.
26. E
FFECT •
– Lights up when the EF
FECT function is on
.
27. +10 • – Lights up and indicate the scope value of effect
parameter to be adjusted 10 units each time
.
28. LOADING MP3: During writing data to the card, It will show ”PC LINK”.