Owner`s manual

ManualsBrandsUS Blaster ManualsDVD-playersCOMPACT DISC PLAYER

TROUBLE SHOOTING

Before going through the check list, check wiring connection. If any of the problems persist after check list

has been made, consult your nearest service dealer.

Then put a new one

Inserting the disc in reverse

direction.

Press the RESET button.

Front panel is not properly fixed

into its place.

The car ignition switch is

not on.

If the power supply is properly

connected to the car accessory

terminal,switch the ignition key

to "ACC"

The fuse is blown. Replace the fuse.

Presence of disc inside the

player.

Remove the disc in the player,

Insert the compact disc with

the label facing upward.

The disc is extremely dirty or

defectiv e.

Clean the disc or try to play a

new one.

Temperature inside the car

is too high.

Cool off or until the ambient

temperature return to normal.

Condensation.

Leave the player off for an hour

then try again.

Volume is in minimum.

Adjust volume to a desired level.

Wiring is not properly

connected.

Check wiring connection.

The installation angle is

more than 30 degrees.

Adjust the installation angle less

than 30 degrees.

The disc is extremely dirty

or defectiv e disc.

Clean the compact disc, then

try to play a new one.

The operation keys

do not work.

The built-in microcomputer

is not operating properly

due to noise.

The antenna cable is not

connected.

Insert the antenna cable firmly.

The signals are too weak.

Select a station manually .

Symptom Cause Solution

This product incorporates copyright protection technology that is protected by method claims of certain U.S.

patents and other intellectual property rights owned by

Macrovision Corporation and other rights owners. Use of this copyright protection

technology must be authorized by Macrovision Corporation, and is intended for home

and other limited viewing uses only unless otherwise authorized by Macrovision

Corporation. Reverse engineering or disassembly is prohibited.