Operation Manual

3
4
1 . STEREO MAIN OUTPUT
Unbalanced RCA connectors controlled by the master fader.
2 . POWER SWITCH
Press the power switch to turn the unit on. To switch the POWER off press the POWER switch
again.
3 .
FUSES
Under normal operation the fuses should not blow. A blown fuse usually indicates
an overload or fault condition. To change the fuse, remove the power cord, pry off
the fuse block with a small flathead screwdriver and change the blown fuses.
Refer to the specification for fuse current ratings.
4 . AC CORD
Used this cable to connect the AC mains power to the unit
5 . SD PORT
Insert the SD card.
6 . USB PORT
Insert the USB.
7 . DISPLAY
TRACK
CUE
MIN .
SEC.
SIN GLE
CONTIN UE ROBO LOOP
ELAPSED TOT AL REMAIN PROGRAM REPEAT 1 ALL PITCH
,
A B
C
DEF
G
HI
J
KLNM
A. OPERATING MODE
These indicate the operating mode of the SD CARD or USB player
: The SD CARD or USB player is playing the SD CARD or USB.
: The playback is paused.
B. TIME MODE INDICATORS
ELAPSED:
TOTAL REMAINING:
REMAINING:
C. “PROGRAM” INDICATOR
This indicates the player is in programme mode.
D . REPEAT INDICATOR
REPEAT 1:
REPEAT ALL:
E. TIME BAR
INDICATOR
This is a graphical representation of the “Minute, second and frame displays” (C).
F. “PITCH” INDICATOR
This indicates the pitch slider (12) is activated.
G. “LOOP” INDICATOR
This indicates the SD CARD or USB player is currently playing
in a preset loop.
H. PITCH DISPLAY
This indicates the playback speed (pitch), from 16% to +16%.
I. PLAY MODE INDICATORS
SINGLE:
CONTINUE:
ROBO:
J. MINUTE, SECOND AND FRAME DISPLAYS
These
displays shows the current time, the value changes depends on the time mode selected.
K. “CUE” INDICATOR
This indicates a new cue is set.
L. TRACK NUMBER
This displays the position, number of track of the SD CARD or USB, which is playing.
M. FOLDER DISPLAY
N. ID3 COMMUNICATION DISPLAY
The SD CARD or USB player is in single mode.
The SD CARD or USB player is in continue mode.
The SD CARD or USB player is in relay mode.
The SD CARD or USB player is playing the selected track repeatedly.
The SD CARD or USB player is playing the entire SD CARD or USB repeatedly.
Played time of the selected track.
Tot al remaining play time of the SD CARD or USB.
Remaining play time of the selected track.
8 . BPM EFX
9 .
FX TAP BUTTON
10. CUE TAP BUTTON
11.
first : control the SD card function.
- Press the second: control the USB function.
- Press along time ,after display “P-OFF” and will shut off the power for SD card/USB.
- If you take away the SD card/USB, then pressing the botton, will start up the SD/USB.
15. SKIP>>I BUTTON
In the “TRACK”mode,is next track.
IN BUTTON ( LOOP SYSTEM )
This button sets the beginning of the loop. The Loop indicator on the display flashes.
12. OUT
BUTTON ( LOOP BUTTON )
When you press this button, you set the end point of the seamless loop and you start the loop.
To finish the loop, press again this button.
13. RELOOP BUTTON ( LOOP SYSTEM )
This button is used to
start the last saved loop.
14. SD/USB BUTTON
- Press the