Operation Manual

GN B

Y U

.S B

ASTER - P.O. Box 5376 - Carefree - AZ 85377 - USA.

USB 7013 - 7014

Console mixers

TEREO INPUT CHANNELS

1.MONITOR OUT

This jack is to be connected with the input jack of a monitor amplifier when

sing separate monitor amplifiers.

/3. AUX 1

Each of these six AUX outputs have a master output level control.

4.L/R PIN JACK

Used for connection of line level equipment. (Tape recorders etc.)

5.GAIN

The GAIN control sets the input level to the channel, allowing to match to

a wide range of line level sources.

6.HF EQ

Turn clockwise to boost high (treble) frequencies, adding crispness to per-

cussion from drum machines, synths and electronic instruments. Turn anti-

clockwise to cut these frequencies, reducing hiss or excessive brilliance. Set

the knob in the center position when not required. The control has a shel-

ving response giving 15 dB of boost or cut at 12 kHz and above.

LF EQ

Turn clockwise to boost low (bass) frequencies, adding extra punch to

synths, guitars and drums. Turn anticlockwise to reduce hum, boominess

or improve a mushy sound. Set the knob to the centre position when not

required. The control has a shelving response giving 15 dB of boost or cut

at 60Hz and below.

7.AUX

This socket sends out the signals from aux bus.

8.EFFECT

Adjust this knob can send a signal to inside or outside effectors.