Installation Guide

Side splash
A B
Backsplash
C
CAUTION!
Back and side
splashes are
extremely fragile
if not handled
properly. Read
carefully before
handling your
new vanity top!
Only turn the top
or backsplash to a
horizontal position
when you are
preparing to install it
on the vanity.
Unpacking Your New Vanity Top
Natural Granite & Infinity Quartz Vanity Tops:
After opening the box, remove the center foam packing blocks.
Your sidesplash is packed behind tape within the foam blocks at
the ends. (see diagram A). Remove the tape, then carefully extract
the sidesplash, and set it on a flat surface.
IF YOU DO NOT REMOVE THE SIDESPLASH BEFORE
UNPACKING THE REST OF THE NEW VANITY TOP, YOU ARE AT
RISK OF BREAKING THE SIDESPLASH.
Remove the foam blocks at either end of the package (see
diagram B). Take care that the vanity top remains well seated in
the box and does not come up with the packing blocks as it may
drop back down and cause damage to the product.
Support the vanity top firmly while extracting it from the box (see
diagram C). Do not set the vanity down unsupported.
Once properly installed, your new vanity top will be supported
around the perimeter and breakage will be very unlikely. If you
have any concerns or discover any breakage before unpacking
the product, notify US Marble immediately.
Handling Instructions for
Your New Vanity Top
LIKE THIS:
NOT LIKE THIS:
Thank you for purchasing a US Marble Vanity Top. Please
read the instructions carefully prior to installing the top. These
are basic instructions for installation in a step-by-step
sequence that will work in most types of installations. If you
have an installation that is not covered here, please contact
US Marble for additional information.
Before Installation: Please contact U.S. Marble if you
feel there is a problem. Warranty states: “United States
Marble is not responsible for any removal, installation, or
labor cost, or any consequential damages as a result of any
defective product.”
Please be Advised:
Keep vanity tops in original packaging and keep level until
you are ready for installation.
Engineered Marble/Granite/Onyx & Solid
Surface Vanity Tops:
Do not remove protective plastic covering from vanity top. This is
used to protect the top surface during installation.
Remove the vanity top from the box & support the vanity top firmly
while extracting it from the package.
Maintain a vertical position while carrying it.
usmarble.com • q [phone] • p [phone] • 7839 Costabella Ave., Remus, MI 49340