Operating instructions

PART I: SECTION B: INTERNAL MODEM INSTALLATION WITH WINDOWS 95
41
How to Prepare for Plug and
Play Installation
1. Touch an unpainted metal part of your
computer (the back is usually unpainted) to
discharge static electricity. Static can
damage your modem.
2. Take the modem out of its plastic bag.
3. Find the COM port and IRQ shunts (small
black plastic pieces) on your modem. They
should be in roughly the area indicated in
the illustration at the right.
4. When doing a “Plug and Play” installation,
you need to take all the shunts off of the
COM and IRQ jumpers. Remove them,
and then replace them so each is sitting on
one jumper pin as shown in the illustration
on the next page.