User`s guide

20
865RERWLFV2QOLQH5HVRXUFHV
Connecting to the U.S. Robotics BBS
To connect to the U.S. Robotics Bulletin Board System, follow these steps:
1. Start your communications software. The software settings for the BBS are as follows:
ANSI terminal emulation
Data Bits: 8
Parity: None
Stop Bits: 1
2. Put your computer in Terminal mode. Enter the following command:
ATDT 01734692200<Enter>
3. If this is your first time connecting to our BBS, you will be asked to enter your name and a password, as
well as fill out a questionnaire.
4. When you finish registering, press enter with each prompt until you come to the main menu. Select the
appropriate letter to perform the desired function.