Installation guide

20
The U.S. Robotics Installation CD-ROM did not automatically launch when I
inserted the Installation CD-ROM.
Possible Solution:
Some programs may keep the autolaunch feature of the Installation CD-ROM from
beginning. Close any open applications and reinsert the Installation CD-ROM. If your CD-
ROM still does not automatically launch, click Windows Start, Run, and type D:\setup (if
your CD-ROM drive uses a different letter, type that letter in place of “D”) and click OK.
I accidentally clicked Cancel during the installation procedure of the 802.11g
54Mbps USB Adapter.
Possible Solution:
Remove and reinsert the U.S. Robotics Installation CD-ROM into your CD-ROM drive.
Repeat the installation procedure of the software before you install any hardware.
My computer does not recognise the 802.11g 54Mbps USB Adapter.
Possible Solution:
The 802.11g 54Mbps USB Adapter may not be properly connected. Make sure the
802.11g 54Mbps USB Adapter is fully inserted into the USB port on your computer.
The 802.11g 54Mbps USB Adapter does not work properly, and I may need to
uninstall the device.
Possible Solution:
Check to be certain the 802.11g 54Mbps USB Adapter is not in use before removing it.
The computer may lock up if the 802.11g 54Mbps USB Adapter is removed while in use. If
the 802.11g 54Mbps USB Adapter is not functioning correctly, perform the following
steps:
Windows XP Users: Click Windows Start, All Programs, 802.11g Wireless USB
Adapter Utility, and then Uninstall.
Windows 98, Me, and 2000 Users: Click Windows Start, Programs, 802.11g
Wireless USB Adapter Utility, and then Uninstall.