Use and Care Manual

EUROSTEAM/US STEAM SANITIZED FOR HEALTH - REDEFINED
EUROSTEAM TRAINING MANUAL Page 12 of 20
ALUMINUM: Use brass brush directly on the surface to remove dirt and to polish.
Wipe with towel.
BLINDS
CAUTION!
NOT RECOMMENDED FOR CLOTH BLINDS - DO NOT USE EXCESSIVE HEAT ON VINYL BLINDS!
SLATS
DUSTING: Open blinds and use 1-hole nozzle on medium to high pressure to blow dust onto a wipe cloth or
on the window and wipe clean.
DEEP CLEANING: Close blinds with top of slats facing you. Use triangle brush with one towel on low or
medium pressure. Wipe side-to-side from the top down. To reach the whole slat spread the slats with the
other hand while wiping. Close the blinds from the opposite direction and clean from the bottom up. Keep
changing towels until clean. If needed, pre-spray the blinds with EUROSTEAM VAPORMATE.
STRINGS: Pull the blind all the way up. Wipe the string with a towel wet with EUROSTEAM VAPORMATE.
Pull the string slowly through a detail brush on medium pressure.
DRAPES
NOTE: VACUUM DRAPES FIRST!
SHEER, ONE-PLY FABRIC
Use triangle brush with one towel, on low or medium pressure, on one side of the pleat AND use the large
rectangular brush with one towel on the other side, to hold curtain steady. Move both brushes at the same
time from top to bottom at medium speed. The steam will go through the fabric and remove dirt from both
sides simultaneously.
INSULATED, MULTIPLE-LAYERED FABRIC
Same technique as SHEER 9.1, but do not move too slow since the insulation is generally heat sensitive. Go
over surface twice.
FURNITURE
UPHOLSTERY
NOTE: ALWAYS CHECK AREA FOR SCOTCH GUARDING.
Using large triangle brush with diapered towel, heat towel on high 3 to 5 seconds. Clean furniture on low
pressure using back and forth movement. If material seems to be getting too wet, cut steam off. Reheat
towel as needed.
LEATHER: Using 1-hole nozzle, blow out cracks and crevasses. Clean the same as upholstery.
VINYL: Using 1-hole nozzle, blow out cracks and crevasses. Use appropriate brush according to the amount
of surface cleaning and amount of dirt on material.