Installation Guide

This heater comes equipped with a

cast-iron ue collar.

Flue Collar - 40292

5/16-18 x 1-1/2" Bolts (3 req.)

Weld Tab (3 req.)

Gasket

Mounting Cast-Iron Flue Collar

KEY DESCRIPTION PART NO. QTY.

1 Blower Housing Back 25089B 1

2 Blower Housing Front 25090B 1

3 Blower Motor 80442 1

4 Rheostat w/Nut and Knob 80090 1

5 Strain Relief Bushing 80109 1

6 Power Supply Cord 80232 1

7 Heat Shield 891861 1

8 10AB x 3/8 Hex Screw 83172 12

N/S #12 x 3/4 Teks Screw C23799 4

ASSEMBLY INSTRUCTIONS

Step 1: THE BLOWER ASSEMBLY MUST BE

DISCONNECTED FROM THE SOURCE OF ELECTRICAL

SUPPLY BEFORE ATTEMPTING THE INSTALLATION.

With pliers, cut the 6 micro-joints and remove panel.

Note: Discard the panel.

Step 2: Fix the assembly to the back of the stove with

the four screws provided.

THE BLOWER ASSEMBLY IS INTENDED FOR USE ONLY

WITH A STOVE THAT IS MARKED TO INDICATE SUCH

USE.

DO NOT ROUTE THE SUPPLY CORD NEAR OR ACROSS

HOT SURFACES!

Blower Assembly