Installation Guide

9
Venting Into A Fireplace
Many people may wish to convert an existing
replace to heater use. Usually, safe connection
of stovepipe to a masonry chimney requires more
effort than connection to a prefabricated chimney.
Always remember to inspect the masonry chimney
and replace. If necessary, clean the ue and smoke
shelf before beginning your installation. Install the
heater into the replace so that the system can be
dismantled for cleaning and inspection.
Before deciding to convert your replace, keep
in mind that some replaces and existing chimneys
are unsafe. They must be structurally sound, and the
ue liner must be in good condition. Do not use a
chimney if it is unlined (should have a re clay tile liner
to protect brickwork). Have it relined professionally.
Clearances to combustibles are explained in the
previous section on masonry chimneys. If you have
any questions regarding the condition of the chimney,
consult a qualied engineer, competent mason, or
knowledgeable inspector.
Many prefabricated replaces fall into the "zero-
clearance replace" category. This is a factory-built
metal replace with multi-layered construction. It
is designed to provide enough insulation and/or air
cooling so that the base, back and sides can be safely
placed in direct contact with combustible oors and
walls. Although many prefabricated replaces have
been tested by nationally recognized organizations
for use as replaces, they have not been tested to
accept heaters. In fact, their use as such may void
the manufacturer's warranty.
Steel-lined replaces, on the other hand, can be used
with heaters. These units use a 1/4-inch rebox liner
and an air chamber in connection with 8 inches of
masonry to meet code. They contain all the essential
parts of a replace, rebox, throat, smoke shelf, and
smoke chamber. Many of them look exactly like a
masonry replace and must be checked closely for
above requirements before installing a wood heater
into them.
Another method frequently used by some people is
to vent the heater directly into the replace. This does
not meet code since the heater is being vented into
another appliance - the replace. This method should
not be attempted because combustion products will
deposit and build up in the rebox or replace. Be
certain not to install a hazard in your house. You will
void your warranty with this installation.
CAUTION: Not all replaces are suitable for installation of a wood heater.