Installation Guide

Attaching the Filter Box to the Furnace

1. Place the Filter Box at the rear of the furnace and route the blower conduit through the

slots provided.

2. Attach the box to the furnace’s Cabinets sides using three(3) of the drill point screws

provided for each side.

3. Make final adjustments to the mounting brackets to insure a proper fit, then tighten

the six(6) screws retaining the brackets to the filter box.

4. After Conduit placement has been determined, install the Conduit Cover over the re-

maining conduit slots using two(2) of the screws provided.

5. Install a standard 16 x 20 filter (not included) in the filter slot and cap it with the cover

and three(3) screws as shown.

IF OPERATIING THE FURNACE IN A POWER OUTAGE, YOU MUST REMOVE THE

FILTER. ONCE POWER HAS BEEN RESTORED, RE-INSTALL THE FILTER AND COVER

FOR NORMAL OPERATION

Use three(3) Drill point Screws provided

Make final adjustments, then tighten

Conduit Cover

Slots for Conduit