Specifications

2
2
Safety Guide
 Check and comply with your provincial /
state and local codes. You must follow
these guidelines.
 Use care when handling the water soften-
ing system. Do not turn upside down,
drop, drag or set on sharp protrusions.
 The water softening system works on 12
volt-60 Hz electrical power only. Be sure to
use only the included transformer.
 Transformer must be plugged into an in-
door 120 volt, grounded outlet only.
 Use clean water softening salts only, at
least 99.5% pure. NUGGET, PELLET or
coarse SOLAR salts are recommended. Do
not use rock, block, granulated or ice
cream making salts. They contain dirt and
sediments, or mush and cake, and will cre-
ate maintenance problems.
 Keep the salt lid in place on the softener
unless servicing the unit or refilling with
salt.
 WARNING: This system is not in-
tended for treating water that is microbio-
logically unsafe or of unknown quality
without adequate disinfection before or
after the system.
PAGE
Safety Guide 2
Proper Installation 3
Unpacking / Inspection 3
Specification 4
Before Starting Installation 5
General Installation 6
Installation Instructions 7
Start Up Instructions 8
Programming 8
About The Water Softener System 10
Specifications 11
Maintenance 13
Sanitize Procedure 15
Valve Powerhead Assembly 16
Valve Body Assembly 18
Trouble Shooting 23
Warranty 24
Table of Contents
For your safety, the information in this manual must be followed to minimize the risk of
electric shock, property damage or personal injury.