Thank you for purchasing US.SPEC product. This manual describes the functions and operation of PA ll-GM iPod interface for GM cars. Please read this manual before installing the product to your vehicle. !!IMPORTANT!! .:. It is strongly recommended that the unit is installed in an accessible location, so that it can later be easily reset or upgraded. •:. Eject ALL CDs from the built-in CD player or CD changer before installation or disconnect the power to radio!!! .:.
1-2 This interface adapter is designed to use either the CD changer control or the XM band control of your GM factory radio for controlling iPod and AUX. Selecting and using these controls for your auxiliary inputs as follows: 1-2-1. Using the CD Changer control: • Set DIP switches # 3 and #4, located at the side panel of the adaptor, to the "ON" position. Your radio will recognize the adapter and will tum on the CD changer icon on display panel.
1-5 Applications PAll-GM is applicable to the following GM vehicles: MAKE MODEL YEAR IPod control use* CADILLAC ESCALADE EXT CTS IRSX 2003-2006 2003-2006 2004-2007 CDCorXM CDCorXM XM CHEVY IMPALA MONTE CARLO 2000-2005 2000-2005 CDCorXM CDCorXM 2003-2006 2005-2007 2005-2006 2003-2006 2007 2003-2007 2003-2007 2004-2007 2005-2006 2004 CDCorXM CDCorXM XM XM XM XM XM XM XM XM CHEVY TRUCKS AVALANCHE COLORADO ** EQUINAX (Equiped WIXM Tuner only) SILVERADO SILVERADO CLASSIC SUBURBAN TAHOE TRAIL BLAZE
• If the playback of a Playlist is manually interrupted by using the iPod 's key pad, and a song or music in a new category is played, the interface module memorizes the last played track number of the new category. "New category" means file, or folder, or Playlist, or artist, etc. which is different from the Playlist being played.
Section 3. WIRE CONNECTION Step 1-a- Decide to use CD changer control or XM control first and then set the DIP switch #3 and #4 position at side panel of PA I1-GM accordingly. (See Section 1-2 instructions above. The adapter is preset to CD changer control mode at factory.) Step I-b- Set the DIP switch #2 to "OFF" position only if the Direct Mode is preferred. Step 2- Remove radio from the dash. Step 3- Unplug the 24 pin and 12 pin connectors from the radio and connect them to US.kSPEC CAS-G7i cable.
CONNECTING & PLAYING of iPod in DIRECT MODE When the iPod is connected to the adapter, the iPod 's screen will go blank for few seconds before the nonnal screen returns. The audio of iPod music will be played back at DISC 5 and Track I. Adjust VOLUME, BASS, TREBLE and etc. as you would nonnally do for the other program sources on the radio. CONNECTING & PLAYING of iPod in HYBRID MODE 5-1 Connecting iPod to the interface After connection, the iPod will take a few moments to change to external control mode.
However, you may add any text after the correct naming of a Playlist. (i.e. GM I-Jazz, GM3_Favorite3 are acceptable Playlist names for PAll-GM iPod interface.) • If no designated GM Playlists are created, PA ll-GM adaptor automatically relates to the first five available Playlists on iPod to DISC number I to 5 regardless Playlist's naming .
Thank you for choosing a USkSPEC product. LTI Enterprises Inc., is committed to providing high quality defect free products. All USkSPEC products are tested before leaving the factory and are warranted against defects in materials and workmanship for a period of one year to the original owner. The one-year warranty period begins at the date of manufacture or the date of original installation. Please see installation registration below.
XM Receiver Location for most OM Vehicles Make Model Year XM Receiver location Buick Rainer LaCross 05-06 2006 Above Pass-side dash panel Behind Rear-Left quarter panel in truck Cadillac CTS SRX 04-07 05-06 Under the rear deck Behind Rear-Right quarter panel Chevy Impala Monte Carlo Corvette Coupe Corvette Conv.
Design Change Notice (032609) (for Model PA11-GM and PA11-VETTE) In order to improve the handling of Audiobook and to support streaming music downloads on iPhone or iTouch, the Hybrid Mode is deleted and design changes are also implemented to Playlist Mode. The guide of playing iPod in the revised Playlist Mode is as follow: 1. In case of CD changer control configuration (use CD or AUX button on radio): 1-1 Configuration A: (RCA AUX is OFF or Disabled) I.
z Song title display on radio is not supported in iPod Direct. z When return to DISC #4 (All Songs) from DISC #5 (iPod Direct), DISC #4 will continue play the track and folder of iPod being played at DISC #5 until the last track of the Folder is completed. IV. If iPod has more than 3 Playlists were created with iTune, please refer to the Playlist Naming section of interface manual.
2. In case of XM control configuration (use BAND button on radio): 1-1 Configuration C: (RCA AUX is OFF or Disabled) V. When iPod is connected to interface and BAND button on radio is pressed, iPod will begin play at P5 (radio displays P5). iPod screen will show “OK to Disconnect” or “Accessory is attached”. iPod will continue play the tracks in the Folder which was played prior to iPod is connected to interface adaptor.
Summary of Playlist Mode Operation for XM control configurations: Configuration A: (RCA OFF) Configuration B: (RCA ON) DIP switch #1=ON DIP switch #1=OFF DIP switch #2=ON DIP switch #2=ON DIP switch #3=OFF DIP switch #3=OFF DIP switch #4 = see Note below DIP switch #4 = see note below At …. Radio Plays At….
