User's Manual

SAR Information Statement

Your wireless phone is a radio transmitter and receiver. It is designed and manufactured not to exceed

the emission limits for exposure to radiofrequency (RF) energy set by the Federal Communications

Commission of the U.S. Government. These limits are part of comprehensive guidelines and establish

permitted levels of RF energy for the general population. The guidelines are based on standards that

were developed by independent scientific organizations through periodic and thorough evaluation of

scientific studies. The standards include a substantial safety margin designed to assure the safety of all

persons, regardless of age and health. The exposure standard for wireless mobile phones employs a unit

of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg.

* Tests for SAR are conducted with the phone transmitting at its highest certified power level in all

tested frequency bands. Although the SAR is determined at the highest certified power level, the actual

SAR level of the phone while operating can be well below the maximum value. This is because the phone

is designed to operate at multiple power levels so as to use only the power required to reach the

network. In general, the closer you are to a wireless base station antenna, the lower the power output.

Before a phone model is available for sale to the public, it must be tested and certified to the FCC that it

does not exceed the limit established by the government adopted requirement for safe exposure. The

tests are performed in positions and locations (e.g., at the ear and worn on the body) as required by the

FCC for each model. The highest SAR value for this model phone when tested for use at the ear is

0.620W/Kg and when worn on the body, as described in this user guide, is 0.907W/Kg(Body-worn

measurements differ among phone models, depending upon available accessories and FCC

requirements). The maximum scaled SAR in hotspot mode is 0.994W/Kg. While there may be differences

between the SAR levels of various phones and at various positions, they all meet the government

requirement for safe exposure. The FCC has granted an Equipment Authorization for this model phone

with all reported SAR levels evaluated as in compliance with the FCC RFexposure guidelines. SAR

information on this model phone is on file with the FCC and can be found under the Display Grant

section of http://www.fcc.gov/ oet/fccid after searching on

FCC ID: 2ADOV-V3 Additional information on Specific Absorption Rates (SAR) can be found on the

Cellular Telecommunications Industry Asso-ciation (CTIA) web-site at http://www.wow-com.com. * In

the United States and Canada, the SAR limit for mobile phones used by the public is 1.6 watts/kg (W/kg)

averaged over one gram of tissue. The standard incorporates a sub-stantial margin of safety to give

additional protection for the public and to account for any variations in measurements.

Body-worn Operation

This device was tested for typical body-worn operations. To comply with RF exposure requirements, a

minimum separation distance of 15mm must be maintained between the user’s body and the handset,

including the antenna. Third-party belt-clips, holsters, and similar accessories used by this device should

not contain any metallic components. Body-worn accessories that do not meet these requirements

may not comply with RF exposure requirements and should be avoided. Use only the supplied or an

approved antenna.